Hyundai Accent Manuals

Hyundai Accent: Disassembly - Front Driveshaft. Repair procedures - Driveshaft Assembly - Driveshaft and axleHyundai Accent: Disassembly

Hyundai Accent RB (2010-2018) Service Manual / Driveshaft and axle / Driveshaft Assembly / Front Driveshaft. Repair procedures / Disassembly

•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
1.
Remove the circlip (B) from the driveshaft spline (A).
2.
Remove both boot bands from the transaxle side joint(TJ) case.
3.
Pull out the boot from transaxle side joint case (B).
4.
While dividing joint(TJ) boot (A) of the transaxle side, wipe the grease in TJ case (B) and collect them respectively.

Make alignment marks on spider roller assembly (A), joint case (B), and shaft spline (C) to aid reassembly.
5.
Remove the snap ring (A) and spider roller assembly (B) from the shaft.
6.
Remove the spider assembly (B) from the driveshaft (A) using the special tool (09495-33000).
7.
Clean the spider assembly.
8.
Remove the boot (A) of the transaxle side joint(TJ).
For reusing the boot (A), wrap tape (B) around the driveshaft splines (C) to protect the boot (A).
9.
Using a plier or flat-tipped (-) screwdriver, remove the both side of clamp (B) of the dynamic damper (A).
10.
Fix the driveshaft (A) with a vice (B) as illustrated.
11.
Apply soap powder on the shaft to prevent being damaged between the shaft spline and the dynamic damper when the dynamic damper is removed.
12.
Saperate the dynamic damper (A) from the shaft (B) carefully.

Inspection
1. Check the driveshaft boots for damage and deterioration. 2. Check the driveshaft spline for wear or damage. 3. ...

Reassembly
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boots. 2. Apply grease to the joint boot on the side of the wheel an ...

See also:

Installation
• Do not use already used injector fixing clip again. ...

Special Service Tools
Special Service Tools Tool (Number and name) Illustration Use 09200-38001,3N000 (Beam) 09200-2S100 (Adapter) 09200-2S200 (Supporter) ...

Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth betwe ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com