ESC Hydraulic System Diagram |
1. |
ESC Non-operation : Normal braking.
|
2. |
ESC operation
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
In the event of inhibition of ABS functions by failure.
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the Parking Brake Switch is ON or brake fluid level is low.
|
- |
When the EBD function is out of order .
|
- |
During diagnostic mode.
|
- |
When the ECU Connector is separated from ECU.
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization phase after IGN ON. (continuously 3
seconds).
|
- |
When the ESC function is inhibited by system failure.
|
- |
When the ESC control is operating. (Blinking - 2Hz)
|
- |
During diagnostic mode.(Except standard mode)
|
- |
Cluster lamp is ON when communication is impossible with CAN module.
|
- |
During the initialization mode after IGN ON. (continuously 3 seconds).
|
- |
ESC Off lamp is On when driver input the ESC Off switch.
|
Inspection
1.
Check the select cable for proper operation and for damage.
2.
Check the shift cable for proper operation and for damage.
...
Removal
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the seat belt after pushing ...
Power Door Lock Actuators. Repair
procedures
Inspection
Front Door Lock Actuator Inspection
1.
Remove the front door trim.
(Refer to the BD group - "Front door")
2.
...