Hyundai Accent: Immobilizer Control Unit. Repair
procedures
Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Immobilizer System / Immobilizer Control Unit. Repair
procedures
Replacement
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the crash pad lower panel.
(Refer to the BD group - "Crash pad")
|
| 3. |
Remove the BCM unit and the SMARTRA unit(A).
[USA]
|
| 4. |
Remove the SMARTRA unit (A) from the bracket with loosening a
shear bolt (B).
[CANADA]
|
| 5. |
Installation is the reverse of removal procedure.
|
Replacement
Problems And Replacement Parts:
Problem
Part set
GDS required?
All keys have been lost
Blank key (4)
YES
An ...
Antenna Coil. Repair procedures
Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds (A) after removing
3 sc ...
See also:
Defroster
CAUTION
To prevent damage to the conductors bonded to the inside surface of the
rear window, never use sharp instruments or window cleaners containing abrasives
to clean the window.
NOTICE
If ...
Installation
Be sure to install the harness wires not to be pinched or interfered
with other parts.
...
Removal
When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com