Front Brake Disc Thickness Check |
1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Front Brake Pad Check |
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check the damage of pad, backing metal and contamination with
grease.
|
Front Brake Disc Runout Check |
1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
3. |
If the runout does not exceed the limit specification, install
the brake disc after turning it 180° and then check the runout of the
brake disc again.
|
4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
Necessary inspections
Fluid levels, such as engine oil, engine coolant, brake fluid, and washer fluid
should be checked on a regular basis, with the exact interval depending on the fluid.
Further details are provided i ...
Oil And Filter Replacement
•
Prolonged and repeated contact with mineral
oil will result in the removal of natural fats ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraul ...