Rear Brake Disc Thickness Check |
1. |
Check the brake pads for wear and fade.
|
2. |
Check the brake disc for damage and cracks.
|
3. |
Remove all rust and contamination from the surface, and measure
the disc thickness at 8 points, at least, of same distance (5mm) from
the brake disc outer circle.
|
4. |
If wear exceeds the limit, replace the discs and pad assembly
left and right of the vehicle.
|
Rear Brake Pad Check |
1. |
Check the pad wear. Measure the pad thickness and replace it,
if it is less than the specified value.
|
2. |
Check the damage of pad, backing metal and contamination with
grease.
|
Rear Brake Disc Runout Check |
1. |
Place a dial gauge about 5mm (0.2 in.) from the outer circumference
of the brake disc, and measure the runout of the disc.
|
2. |
If the runout of the brake disc exceeds the limit specification,
replace the disc, and then measure the runout again.
|
3. |
If the runout exceeds the limit specification, install the brake
disc after turning it 180° and then check the runout of the brake disc
again.
|
4. |
If the runout cannot be corrected by changing the position of
the brake disc, replace the brake disc.
|
General Service Information
Protection Of The Vehicle
Always be sure to cover fenders, seats, and floor areas before
starting work.
The support rod m ...
Roof Trim. Repair procedures
Replacement
Sunvisor Replacement
•
When prying with a flat-tip screwdriver, wrap it with
...
Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...