Hyundai Accent: Inspection
Lighting Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the multifunction switch.
Lighting switch
HS : Head lamp switch(Short inside)
Dimmer And Passing Switch
HU : Head lamp high beam
HL : Head lamp low beam
HF : Head lamp passing switch
HS : Head lamp switch(Short inside)
Turn Signal Switch
Front Fog Lamp Switch
Wiper And Washer Switch Inspection
With the multifunction switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified, replace
the multi-function switch.
Wiper Switch (Intermittent)
INT 1 : Intermittent switch 1(Short inside)
INT 2 : Intermittent switch 2(Short inside)
B1 : B1(Short inside)
Wiper Switch
Washer Switch
Wiper and Washer Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper (A) and lower (B) shrouds aft ...
See also:
Side repeater light bulb replacement
Type A
1. Remove the light assembly from the vehicle by prying the lens and pulling
the assembly out.
2. Disconnect the bulb electrical connector.
3. Separate the socket and the lens parts by t ...
Inspection
Connecting Rod And Crankshaft
1.
Check the connecting rod end play.
Using feeler gauge, measure the end play while moving
the connecting rod back and f ...
Curtain Airbag (CAB) Module. Description
and Operation
Description
Curtain airbags are installed inside the headliner (LH and RH) and protect
the driver and passenger from danger when side crash occurs. The SRSCM determines
deployment of curtain ...