1. |
With the washer motor connected to the reservoir tank, fill the
reservoir tank with water.
|
2. |
Connect positive (+) battery cables to terminal 1 and negative
(-) battery cables to terminal 2 respectively.
|
3. |
Check that the motor operates normally and the washer motor runs
and water sprays from the front nozzles.
|
4. |
If they are abnormal, replace the washer motor.
Connector No.1 : Windshield washer(+),
2 : Ground
|
Accelerator Position Sensor
(APS). Description and Operation
Description
Accelerator Position Sensor (APS) is installed on the accelerator
pedal module and detects the rotation angle of the accelerator pedal. The APS
is one of the most important senso ...
Rear Wheel Alignment
When using a commercially available computerized wheel alignment
equipment to inspect the rear wheel alignment, always position ...
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the VIS valve connector.
3.
Measure resistance between VIS valve ...