1. |
Turn ignition switch OFF and disconnect the negative
(-)battery cable.
|
2. |
Remove the fuel pump assembly.
|
3. |
Check motor operation by fuel pump connector (A)
connecting power(No.2) and ground(No.4)
|
1. |
Using an ohmmeter, measure the resistance between
terminals 1 and 3 of sender connector (A) at each float level.
|
2. |
Also check that the resistance changes smoothly when
the float is moved from "E" to "F".
|
Trunk Trim. Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
...
Checking Cables And Wires
1.
Check the terminal for tightness.
2.
Check terminals and wires for corrosion from battery
electrolyte, etc.
3.
...
Description and Operation
Description
The charging system included a battery, an alternator with
a built-in regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectif ...