Clutch Pedal Inspection |
1. |
Measure the clutch pedal height (from the face of
the pedal pad to the floor board) and the clutch pedal clevis pin play
(measured at the face of the pedal pad.)
|
Ignition Lock Switch Inspection |
1. |
Disconnect 2P-connector from a ignition lock switch.
|
2. |
Disconnect the ignition lock switch. (if you can
install a tester with the switch fixed, this step can be omissible)
|
3. |
Check for continuity between terminals. (refer to
the table below)
|
Tightening Torques
Engine Control System
Item
kgf.m
N.m
lb-ft
ECM installation bolt
1.0 ~ 1.2
9.8 ~ 11.8
7.2 ~ 8.7
...
Troubleshooting
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetoot ...
Scheduled maintenance service
Follow Normal Maintenance Schedule if the vehicle is usually operated where none
of the following conditions apply. If any of the following conditions apply, follow
Maintenance Under Severe Usage ...