1. |
Disconnect the back up lamp switch connector (A).
|
2. |
Check the continuity between no. 1 and 2 terminals of backup lamp
switch. When the shift lever is in reverse, there should be continuity.
|
3. |
If necessary, repair or replace the backup lamp switch.
|
Projected Dimensions ( 5 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole (Ø8.6)
Front sub frame m ...
Interior Trim. Components and Components
Location
Components
1. Front pillar trim
2. Center pillar lower trim
3. Center pillar upper trim
4. Rear pillar trim [4 Door]
5. Rear wheelhousing trim
6. Front door scuf ...
Replacement
1.
Disconnect the battery negative cable from the battery and then
wait for at least 30 seconds.
2.
Turn the steering wheel so that the fro ...