1. |
Turn ignition switch OFF.
|
2. |
Disconnect the oil temperature sensor connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
Sub Frame. Repair procedures
Replacement
1.
Remove the front wheel & tire.
Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
...
Removal
PODS-F ECU
1.
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
2.
Remove the front pa ...
Inspection
Antenna Cable
1.
Remove the antenna jack from the audio unit and antenna.
2.
Check for continuity between the center poles of antenna cable ...