Hyundai Accent: Inspection
| 1. |
Turn ignition switch OFF.
|
| 2. |
Disconnect the oil temperature sensor connector.
|
| 3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
| 4. |
Check that the resistance is within the specification.
|
Removal
1.
Remove the battery and the battery tray.
(Refer to "Charging system" in EE group.)
2.
Remove the under cover (A).
...
See also:
Repair procedures
General Inspection
After or before servicing the EPS system, perform the troubleshooting
and test procedure as follows. Compare the system condition with normal condition
in the table below ...
Disassembly
1.
Disconnect the M-terminal (A) on the magnet switchassembly.
2.
After loosening the 2 screws (A), detach the magnetswitch
assembl ...
Installation
1.
Installation is reverse of removal.
PCV Valve installation:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7
lb-ft)
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com