1. |
Turn ignition switch OFF.
|
2. |
Disconnect the oil temperature sensor connector.
|
3. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
4. |
Check that the resistance is within the specification.
|
Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine
coolant, then install it on a pressure tester.
2.
Ap ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Trunk Trim. Repair procedures
Replacement
•
Put on gloves to protect your hands.
•
...