Hyundai Accent: Inspection

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures / Inspection

1.	Turn ignition switch OFF.

2.	Disconnect the oil temperature sensor connector.

3.	Measure resistance between sensor signal terminal and sensor ground terminal.

4.	Check that the resistance is within the specification.

Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Repair procedures

...

Removal

Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraul ...

See also:

Installation
Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

Seat Belt Pretensioner (BPT). Description and Operation
Description The Seat Belt Pretensioners (BPT) are installed inside Center Pillar (LH & RH). When a vehicle crashes with a certain degree of frontal impact, the pretensioner seat belt hel ...

Repair procedures
Inspection Front Door Lock Actuator 1. Remove the front door trim. (Refer to the Body group - Front door) 2. Remove the front door ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com