Hyundai Accent Manuals

Hyundai Accent: Installation - Passive Occupant Detection System (PODS-F). Repair procedures - SRSCM - Restraint (Advanced)Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Restraint (Advanced) / SRSCM / Passive Occupant Detection System (PODS-F). Repair procedures / Installation

PODS-F ECU
1.
Install the PODS-F ECU equipped seat track assembly.
(Refer to the Body group - "Seat")
2.
Install the seat cushion cover assembly.
(Refer to the Body group - "Seat")
3.
Install the front passenger seat assembly.
(Refer to the Body group - "Seat")
4.
Reconnect the battery negative cable.
5.
After installing the PODS-F, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
Be sure to perform PODS-F reset with GDS after replcacing PODS-F equipped seat cushion.
PODS-F Mat
1.
Install the PODS-F Mat equipped seat cushion assembly.
(Refer to the Body group - "Seat")
2.
Install the front passenger seat assembly.
(Refer to the Body group - "Seat")
3.
Reconnect the battery negative cable.
4.
After installing the PODS-F, confirm proper system operation :
A.
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
B.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the PODS-F does not require suppression and the passenger airbag is enabled.
Be sure to perform PODS-F zeroing with GDS after replcacing PODS-F equipped seat cushion.

Removal
PODS-F ECU 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front pa ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

See also:

Circuit Diagram (1)
...

To set cruise control speed
1. Push the cruise ON-OFF button on the steering wheel to turn the system on. The CRUISE indicator light in the instrument cluster will illuminate. 2. Accelerate to the desired speed, which must ...

Repair procedures
Inspection Manual Transaxle Oil Inspection 1. Park the vehicle on a level ground and stop the engine. 2. Retighten the oil f ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com