Hyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Ignition Switch Assembly / Repair procedures / Installation

1.

Install the key lock cylinder.

When assembling, the key must be inserted at 'ACC' position.

2.	Install the key warning and immobilizer connector.

3.	Install the ignition switch.

4.	Install the steering column shrouds and crash pad lower panel.

Removal

1. Disconnect the negative (-) battery terminal. 2. Remove the steering column upper and lower shrouds. (Refer to the ST group - & ...

See also:

Side Airbag (SAB) Module. Description and Operation
Description The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airba ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS). Specifications
Specifications Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14 ~ 9.81 (5.5 ~ 0.1, 7.82 ~ 1.42) ...

PODS-F Zeroing procedure
You should perform PODS-F Re-zero procedure after service or replacement about all part of the passenger seat. (Not included full seat assembly) 1. Ignition “OFF” ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com