When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
1. |
Installation is reverse of removal.
|
Anchor Pretensioner (APT). Description and Operation
Description
Front anchor pretensioner operates as well as Belt Pretensioner at the
same time If it gets into its deploy condition after a collision. It is located
at near anchor on driver se ...
Removal
•
Do not spill brake fluid on the vehicle;
it may damage the paint if brake fluid does contac ...
Side Body B ( 4Door )
Side outer panel notch
Side outer panel notch
Side outer panel notch
...