Hyundai Accent Manuals

Hyundai Accent: Installation - Manifold Absolute Pressure Sensor (MAPS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Installation is reverse of removal.
Manifold absolute pressure sensor installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor con ...

Intake Air Temperature Sensor (IATS). Description and Operation
Description Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction o ...

See also:

Fuses
A vehicle’s electrical system is protected from electrical overload damage by fuses. This vehicle has 2 fuse panels, one located in the driver’s side panel bolster, the other in the engine ...

Checking the tire inflation pressure
1.After driving approximately 4~6miles (7~10km or about 10min), stop at a safety location. 2.Connect connection hose (9) of the compressor directly to the tire valve. 3.Plug the compressor power c ...

Components(2)
[Sedan] 1. Roof trim 2. Retainer 3. Sunvisor 4. Assist handle ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com