Hyundai Accent Manuals

Hyundai Accent: Installation - Knock Sensor (KS). Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Knock Sensor (KS). Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
1.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the intake manifold (Refer to “Intake And E ...

Heated Oxygen Sensor (HO2S). Description and Operation
Description Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies ...

See also:

Inspection
1. Turn ignition switch OFF. 2. Disconnect the oil temperature sensor connector. 3. Measure resistance between ...

ECM Terminal And Input/Output signal [A/T]
ECM Terminal Function (A/T) Connector [EGGA-AG] Pin No. Description Connected to 1 Injector (Cylinder #1) [High] ...

Tail lamp warning chime
If you turn the ignition switch to the OFF position with the tail lamps ON and the driver's door in an open position, the warning chime will sound. To stop the chime, perform one of the followi ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com