Hyundai Accent Manuals

Hyundai Accent: Installation - Variable Intake Solenoid (VIS) Valve. Repair procedures - Engine Control System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Engine Control System / Variable Intake Solenoid (VIS) Valve. Repair procedures / Installation

•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
•
Use care to keep foreign material out of the valve.
1.
Installation is reverse of removal.

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the variable intake solenoid valve connector ...

Fuel Pressure Control Valve. Description and Operation
Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

See also:

Adjustment
Clutch Release Cylinder Air Bleeding Procedure Use the specified fluid. Avoid mixing different brands of fluid ...

Removal
1. Turn ignition switch OFF. 2. Disconnect the brake fluid level switch connector (A) from the reservoir. 3. ...

Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com