Hyundai Accent: Installation

Removal

1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector ...

Delivery Pipe. Repair procedures

...

See also:

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the rear seat (Refer to "Seat" in BD gro ...

Inspection
Radiator Cap Testing 1. Remove the radiator cap, wet its seal with engine coolant, then install it on a pressure tester. 2. Ap ...

Inspection
1. Immerse the thermostat in water and gradually heat the water. 2. Check the valve opening temperature. ...