Hyundai Accent Manuals

Hyundai Accent: Installation - Delivery Pipe. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Engine Control/Fuel System / Fuel Delivery System / Delivery Pipe. Repair procedures / Installation

•
Do not use already used injector fixing clip again.
Do not reuse the support disc.
Do not reuse the injector rubber washer.
Do not reuse the combustion seal.
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
•
Apply engine oil to the injector O-ring.
•
Do not use already used injector O-ring again.
•
Do not use already used bolt again.
•
When insert the injector, be careful not to damage the injector tip.
1.
Installation is reverse of removal.
Delivery pipe installation bolt:
18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft)
High pressure fuel pipe installation nut:
26.5 ~ 32.4 N.m (2.7 ~ 3.3 kgf.m, 19.5 ~ 23.9 lb-ft)

Removal
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury ...

High Pressure Fuel Pump. Repair procedures
...

See also:

Components
[RH] 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. T ...

Air cleaner
Filter replacement It must be replaced when necessary, and should not be cleaned and reused. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed ...

Back-up Lamp Switch. Description and Operation
Description Back up lamp switch is pushed by the reverse lug sliding when select arm, and switches the back up lamp. ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com