Hyundai Accent Manuals

Hyundai Accent: Installation - Clutch Cover And Disc. Repair procedures - Clutch System - Clutch SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Clutch System / Clutch System / Clutch Cover And Disc. Repair procedures / Installation

If reinstalling used cover, the cover should be installed with its clutch disc as a set.
1.
Replace a clutch cover and disc as a set.
•
When replacing only a disc, a slip problem can occur because of the load loss due to uneven surface wear.
•
When replacing only a disc, it can be difficult to cut power because the thickness of the disc won't permit it.
2.
Apply grease on a disc spline part and transmission input shaft spline part as required.
* Possible problems when not following
-
When not applying: Excessive wear of splines and bad clutch operation can occur.
-
When excessively applying: Grease can be scattered bycentrifugal force which can conteminate the clutch disc. This can cause a loss of friction force causing a slip.

3.
The 'T/M SIDE' marked surface should face the transmission.
* Possible problems when the disc is installed in the opposite direction.
•
There can be an interference between the concentric slave cylinder on the TM side and a engine flywheel surface.
•
Transaxle shift errror or a strangesound can occur due to clutch separation.

4.
Install the clutch disc and the cover with SST(A : 09411-1P000).

5.
Install the clutch cover bolts. Not to be bent or twisted, Tighten them in diagonal directions.
Tightening torque:
14.7 ~ 21.6 N.m (1.5 ~ 2.2 kgf.m, 10.8 ~ 15.9 lb-ft)
•
Loosely tighten every clutch cover bolts, then torque to specifications in a diagonal direction. This can prevent twisting, vibration of the cover, and the lifting of the pressure plate.
•
Install the all the components with the specified torques. If not, the clutch torque transmission may have concerns or the mounting bolt can loosen.

6.
Install the transaxle assembly.
(Refer to "Manual transaxle system" in MT group)

Inspection
1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing. 2. Check the clutch cover and disc surface f ...

Clutch Master Cylinder. Components and Components Location
Components 1. Reverse hose 2. Master cylinder 3. Clutch switch 4. Ignition lock switch 5. Pedal pad ...

See also:

Changing the coolant
Have coolant changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. CAUTION Put a thick cloth or fabric around the radiator cap before ref ...

Front fog light
Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow etc. The fog lights will turn on when fog light switch (1) is turned to ON after the headlight ...

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mu ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com