Hyundai Accent Manuals

Hyundai Accent: Installation - Automatic Transaxle. Repair procedures - General Information - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / General Information / Automatic Transaxle. Repair procedures / Installation

1.
Installation is the reverse of removal.
If the oil seal on the transaxle case side is damaged and fluid is leaking, replace the oil seal with a new unit. When installing the new oil seal, use the specialized tool (oil seal installer, 09452-26100).
After replacement or reinstallation procedure of the automatic transaxle assembly, perform procedures below.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)
•
After servicing or replacing the automatic transaxle TCM, clear the diagnostic trouble codes (DTC) using the GDS tool.
Diagnostic trouble codes (DTC) cannot be cleared by disconnecting the battery.
•
When replacing the automatic transaxle and TCM, reset the diagnostic trouble code by using GDS.
•
Delete statement, use the GDS as possible.
•
When replacing the automatic transaxle, reset the automatic transaxle's values by using the GDS, A/T menu, "Option Treatment" and "Resetting Auto T/A Values".
•
Perform TCM learning after replacing the transaxle to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the following items; A. Engine cover (A). B. Air cleaner assembly and air duct (B). ...

Hydraulic System
...

See also:

Troubleshooting
Troubleshooting Symptom Suspect area Engine will not start or struggle to start Vapor hose damaged or disconnected Engine strugg ...

General Safety Information and Caution
Precautions General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, ...

Inspection
1. Inspect diaphragm spring wear which is in contact with a concentric slave cylinder bearing. 2. Check the clutch cover and disc surface f ...

Hyundai Accent Manuals


© 2011-2025 Copyright www.hamanual.com