Hyundai Accent Manuals

Hyundai Accent: Installation - Input Speed Sensor. Repair procedures - Automatic Transaxle Control System - Automatic Transaxle SystemHyundai Accent: Installation

Hyundai Accent RB (2010-2018) Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor. Repair procedures / Installation

1.
Installation is the reverse of removal.
•
The gasket of the valve body cover gasket (A) use new one.
•
Adding automatic transaxle fluid.
(Refer to "Hydraulic system (Fluid)" in this group)

•
Perform TCM learning after replacing the automatic transaxle to prevent slow automatic transaxle response, jerky acceleration and jerky startup.
(Refer to "Automatic transaxle control system (Repair procedures)" in this group)

Removal
1. Remove the battery and the battery tray. (Refer to "Charging system" in EE group.) 2. Remove the under cover (A). ...

Output Speed Sensor. Description and Operation
Description The output speed sensor (A) is a vital unit that measures the rate of rotation of the transaxle's turbine shaft and output shaft, and delivers the readings to the TCM. The se ...

See also:

Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Wheel replacement
When replacing the metal wheels for any reason, make sure the new wheels are equivalent to the original factory units in diameter, rim width and offset. WARNING A wheel that is not the correct si ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired positio ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com