|
1. |
Slide the sensor-valve unit through the valve hole of the rim.
Hold the sensor against the rim and the rubber grommet against the sealing
surface.
|
2. |
Insert the nut over the valve stem and then tighten the nut.
|
3. |
Continue to tightening the nut until contact with the rim and
then tighten to 3.5 ~ 4.5Nm.
|
4. |
Check that the sensor is firmly attached to the rim.
|
5. |
Carry out inflation / pressure correction and then fit valve cap.
|
6. |
Install the tire. (Refer to "Tire Installation")
Sensor ID Writing (Wireless)
Sensor ID Writing
|
Removal
1.
Remove valve core and deflate the tire.
2.
Remove the side of the tire bead area from the wheel using tire
changing machine .
...
Components Location
Supplemental Restraint System Control
Module (SRSCM)
Driver Airbag (DAB) / Passenger Airbag
(PAB)
Side Airbag (SAB)
Curtain Airbag (CA ...
Removal and Installation
1.
Disconnect the battery terminals. (Refer to Engine
and transaxle assembly in this group)
2.
Remove the air cleaner assembly. (Refer to E ...