|
1. |
Install the new front impact sensor.
|
2. |
Tighten the front impact sensor mounting bolt.
|
3. |
Connect the front impact sensor connector.
|
4. |
Install the washer reservoir.
(Refer to the Body Electrical group - "Washer motor")
[Right side only]
|
5. |
Install the front bumper.
(Refer to the Body group - "Front bumper")
|
6. |
Reconnect the battery negative cable.
|
7. |
After installing the Front Impact Sensor, confirm proper system
operation:
|
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes.
...
Projected Dimensions ( 4 Door )
Front side member tooling hole (Ø6.6)
Side cover mounting hole
(B/B’: Ø6.6/ Ø8.6)
...
Vehicle identification number (VIN)
The vehicle identification number (VIN) is the number used in registering your
car and in all legal matters pertaining to its ownership, etc.
The number is punched on the floor under the front pa ...