|
1. |
Install the new side impact sensor with the bolt then connect
the side impact sensor connector.
|
2. |
Install the center pillar trim.
(Refer to the Body group - "Interior trim")
|
3. |
Install the door scuff trim.
(Refer to the Body group - "Interior trim")
|
4. |
Reconnect the battery negative cable.
|
5. |
After installing the Side Impact Sensor, confirm proper system
operation:
|
High beam operation
To turn on the high beam headlights, push the lever away from you. Pull it back
for low beams.
The high beam indicator will light when the headlight high beams are switched
on.
To prevent the ...
Repair procedures
Adjustment
TCM Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learnin ...
Rear combination light bulb replacement (4 Door)
(1) Stop and tail light
(2) Rear turn signal light
(3) Back-up light
(4) Side marker
1. Open the trunk lid.
2. Remove the service cover by pulling out the service cover.
3. Remove the sock ...