1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
3. |
Connect the clock spring harness connector to the clock spring.
|
4. |
Install the steering column shroud.
|
5. |
Set the center position by setting the marks between the clock
spring and the cover into line. Make an array the mark (▶◀) by turning
the clock spring clockwise to the stop and then 2.0 revolutions counterclockwise.
|
6. |
Install the steering wheel. (Refer to the Steering System group
- "Steering Column and Shaft")
|
7. |
Connect the driver airbag (DAB) module connector, and then install
the driver airbag (DAB) module on the steering wheel.
|
8. |
Secure driver airbag (DAB) with the new mounting bolts.
|
9. |
Connect the battery negative cable.
|
10. |
After installing the airbag, confirm proper system operation:
|
Hill-start assist control (HAC)
Hill start Assist Control is a convenience function. The main intent is to prevent
the vehicle from rolling backwards while taking off uphill from a stop. HAC holds
the braking pressure built up b ...
SS-A Solenoid Valve(ON/OFF). Description and Operation
Description
SS-A solenoid valve is attached to the valve body and is an on/off solenoid
valve that is used to change gears. SS-A Solenoid valve(ON/OFF) is installed
at valve body.
...
Installation
1.
Installation is the reverse of removal.
2.
Tighten the HECU mounting bolts and nuts to the specified torque.
3.
...