Hyundai Accent: Installation| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable from battery and wait for
at least three minutes before beginning work.
|
| 3. |
Place a passenger airbag on the crash pad and tighten the passenger
airbag mounting bolts.
|
| 4. |
Install the crash pad.
(Refer to the Body group - "Crash pad")
|
| 5. |
Tighten the passenger airbag mounting bolts.
|
| 6. |
Connect the passenger airbag harness connector to the SRS main
harness connector.
|
| 7. |
Reinstall the glove box housing.
(Refer to the Body group - "Crash pad")
|
| 8. |
Reconnect the battery negative cable.
|
| 9. |
After installing the passenger airbag (PAB), confirm proper system
operation:
|
Removal
Side Airbag (SAB) Module. Description
and OperationRemoval
1.
Drain the brake fluid through the bleed plug (A).
2.
Remove the clutch release cylinder assembly (C) after
removing thd tube (B) ...
Lift And Support Points
When heavy rear components such as suspension, fuel
tank, spare tire, tailgate and trunk lid are to be removed, place additiona ...
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Disconnect the manifold absolute pressure sensor
con ...