Hyundai Accent: Measuring Actual Dimensions
Hyundai Accent RB (2010-2018) Service Manual / General Information / Measuring Actual Dimensions
| 1. |
These dimensions indicate the actual linear distance
between measurement points, and are used as the reference dimensions
when a tracking gauge is used for measurement.
|
| 2. |
First adjust both probes to the same length (A=A')
before measurement.
|
Dimensions Projected
1.
These are the dimensions measured when the measurement
points are projected from the vehicle's surface, and are the reference
dimensions used for used for body ...
Measurement Point
Measurements should be taken at the center of the hole.
...
See also:
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...
Inspection
Armature
1.
Remove the starter.
2.
Disassemble the starter as shown at the beginning
of this procedure.
3 ...
Interior D ( 4Door )
Seatbelt height adjust upper mounting hole (Ø15)
Seatbelt height adjust lower mounting hole (Ø15)
...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com