Hyundai Accent: Oil Pressure Switch. Repair
procedures
Hyundai Accent RB (2010-2018) Service Manual / Engine Mechanical System / Lubrication System / Oil Pressure Switch. Repair
procedures
Inspection
| 1. |
Check the continuity between the terminal and the
body with an ohmmeter. If there is no continuity, replace the oil pressure
switch.
|
| 2. |
Check the continuity between the terminal and the
body when the fine wire is pushed. If there is continuity even when
the fine wire is pushed, replace the switch.
|
| 3. |
If there is no continuity when a 49.0kpa (0.5kg/cm²,
7.1psi) is applied through the oil hole, the switch is operating properly.
Check for air leakage. If air leaks, the diaphragm
is broken. Replace it.
|
Installation
1.
Install the oil pan.
(1)
Using a razor blade and gasket scraper, remove
all the old packing material from the gasket surfaces.
...
See also:
Removal
1.
Remove the mounting bolt and disconnect the horn connector, then
remove the horn (A).
...
Adjustment
Adjusting the control cable
1.
Set room side AT lever(shift lever) and automatic transaxle side
manual control lever to "N" position.
2. ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to the ST group - & ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com