Inspection
1. |
Remove the front door trim.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door latch.
|
3. |
Disconnect the 5P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the rear door trim.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door latch.
|
3. |
Disconnect the 5P connector from the actuator.
|
4. |
Check actuator operation by connecting power and ground according
to the table. To prevent damage to the actuator, apply battery voltage
only momentarily.
|
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Remove the front door latch.
|
3. |
Disconnect the 5P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
when inserting the key into the door according to the table.
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Remove the rear door latch.
|
3. |
Disconnect the 5P connector from the actuator.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
Removal
1.
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
2.
Remove the rear seat (Refer to "Seat" in BD gro ...
Replacement
Tail Gate Trim Replacement
•
When prying with a flat-tip screwdriver, wrap it with
prote ...
Removal and Installation
1.
Disconnect the battery negative terminal.
Tightening torque
(-) terminal :
4.0 ~ 6.0N.m (0.4 ~ 0.6kgf.m, 3.0 ~ 4.4l ...