Inspection
1. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
2. |
Disconnect the connector from the motor.
|
3. |
Connect the motor terminals No.4 directly to battery voltage (12V)
and connect the motor terminals No.3 and No.6 directly to battery (-).
And then check that the motor operates smoothly. If the operation is
abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General]
|
1. |
Remove the rear door trim panel.
(Refer to the BD group - "Rear door")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Description and Operation
Description
The starting system includes the battery, starter, solenoid
switch, inhibitor switch (A/T), ignition switch, ignition lock switch, connection
wires and the battery cable.
Whe ...
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, or related fuse is
blown, you must reset your sunroof system as follows:
1. Turn the ignition switch to the ON position and close the sun ...
Description and Operation
Description
The charging system included a battery, an alternator with
a built-in regulator, and the charging indicator light and wire.
The Alternator has eight built-in diodes, each rectif ...