Hyundai Accent Manuals

Hyundai Accent: Rear Wheel Alignment - Alignment. Repair procedures-Revised - Tires/Wheels - Suspension SystemHyundai Accent: Rear Wheel Alignment

When using a commercially available computerized wheel alignment equipment to inspect the rear wheel alignment, always position the vehicle on a level surface.
Prior to inspection, make sure that the rear suspension system is in normal operating condition and that the tires are inflated to the specified pressure.
Toe


B - A. 0: Toe in (+)
B - A < 0: Toe out (-)

Toe is pre-set at the factory, so it does not need to be adjusted. If the toe is not within the standard value, replace or repair the damaged parts and then inspect again.

Toe:
Total : 0.5° (+0.4°/ -0.5°)
Individual :0.25°(+0.2°/ -0.25°)

Camber
Camber is pre-set at the factory, so it does not need to be adjusted. If the camber is not within the standard value, replace or repair the damaged parts and then inspect again.

Camber : -1.5°±0.5°


Front Wheel Alignment
When using a commercially available computerized wheel alignment equipment to inspect the front wheel alignment, always positio ...

Wheel. Repair procedures
Hub Nut Tightening Sequence Tighten the hub nuts as follows. Tightening torque : 88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft) ...

See also:

Additional safety precautions
Never let passengers ride in the cargo area or on top of a foldeddown back seat. All occupants should sit upright, fully back in their seats with their seat belts on and their feet on the flo ...

Repair procedures
Adjustment TCM Learning When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed. In the following case, TCM learnin ...

To keep locks from freezing
To keep the locks from freezing, squirt an approved de-icer fluid or glycerine into the key opening. If a lock is covered with ice, squirt it with an approved de-icing fluid to remove the ice. If ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com