Hyundai Accent: Reassembly
| 1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boots.
|
| 2. |
Apply grease to the joint boot on the side of the wheel and install
the boot.
|
| 3. |
Install the clamp.
|
| 4. |
Assemble the transaxle side joint boot and bands.
|
| 5. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and snap ring (B) on the driveshaft
splines (C).
|
| 6. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
| 7. |
Install the both boot band.
|
| 8. |
To control the air in the TJ boot, keep the specified distance
between the boot bands when they are tightened.
|
|||||||||||||
| 9. |
Using the SST (09495-3K000), secure the TJ boot band.
|
Disassembly
•
Do not disassemble the BJ assembly.
•
Speci ...
See also:
Reporting safety defects
If you believe that your vehicle has a defect which could cause a crash or could
cause injury or death, you should immediately inform the National Highway Traffic
Safety Administration (NHTSA) in ...
Canister Close Valve (CCV). Specifications
Specification
Item
Specification
Coil Resistance (Ω)
19.8 ~ 20.8 [20°C(68°F)
...
General Information
General
The supplemental restraint system (SRS) is designed to supplement the
seat belt to help reduce the risk or severity of injury to the driver and passenger
by activating and deploying ...
Hyundai Accent Manuals
© 2011-2026 Copyright www.hamanual.com