Hyundai Accent Manuals

Hyundai Accent: Removal - Passenger Airbag (PAB) Module. Repair 
procedures - Airbag Module - Restraint (Advanced)Hyundai Accent: Removal

1.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
2.
Remove the glove box housing.
(Refer to the Body group - "Crash pad")
3.
Disconnect the passenger airbag connector (A) and remove the PAB mounting bolt (B).

4.
Remove the crash pad.
(Refer to the Body group - "Crash pad")
Replace the crash pad which is damaged while PAB is deployed.
5.
Remove the mounting bolts from the crash pad. Then remove the passenger airbag.

The removed airbag module should be stored in a clean, dry place with the airbag cushion up.

Passenger Airbag (PAB) Module. Repair procedures
...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

See also:

SRSCM Connector terminal
Pin Function (Connector A) Pin Function (Connector B) 1 Ignition 1 Seat belt pretensioner [Drive ...

Inspection
1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

Installation
• Install the component with the specified torques. • ...

Hyundai Accent Manuals


© 2011-2024 Copyright www.hamanual.com