1. |
Turn ignition switch OFF.
|
2. |
Remove the battery and battery tray.
(Refer to Engine Electrical group - "Battery")
|
3. |
Disconnect the vacuum hose (A) from the brake booster.
|
4. |
Remove the master cylinder.
(Refer to Master cylinder.)
|
5. |
Remove the snap pin (A) and clevis pin (B).
|
6. |
Remove the brake booster mounting nuts (A).
|
7. |
Disconnect the brake tubes (A) from the HECU by unlocking the
nuts counterclockwise with a spanner.
|
8. |
Remove the brake tubes mounting nuts (A).
|
9. |
Pivot the brake tubes (A) down out of the way.
|
10. |
Remove the brake booster (B).
|
Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch ...
Release Residual Pressure in Fuel Line
Whenever the high pressure fuel pump, fuel pipe,
delivery pipe, or injector is removed immediately after shutting off
the ...
Headlamp delay
If you turn the ignition switch to the ACC or OFF position with the headlights
ON, the headlights remain on for about 20 minutes. However, if the driver’s door
is opened and closed, the headligh ...