Rear Disc Brake Type |
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console.
(Refer to Body group - "Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Remove thd floor console rear mounting bracket (A).
|
4. |
Loosen the adjusting nut (A) and the parking brake cables.
|
5. |
Remove the parking brake lever assembly after removing the bolts.
|
6. |
Raise the vehicle, and make sure it is securely supported.
|
7. |
Remove the rear tire and wheel.
|
8. |
Remove the parking brake cable (A), after removing the clip (B).
|
9. |
Loosen the parking brake cable bracket bolts and remove the parking
brake cable.
|
Rear Drum Brake Type |
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
1. |
Remove the floor console. (Refer to Body group.-"Floor console")
|
2. |
Disconnect the connector (A) of parking brake switch.
|
3. |
Remove the floor console rear mounting bracket (A).
|
4. |
Loosen the adjusting nut (A) and the parking brake cables.
|
5. |
Remove the parking brake lever assembly after removing the bolts.
|
6. |
Raise the vehicle, and make sure it is securely supported.
|
7. |
Remove the rear tire and wheel.
|
8. |
Remove the parking brake cable from the brake shoe. (Refer to
the rear drum brake)
|
9. |
Remove the parking brake cable (A), after removing the clip (B).
|
10. |
Loosen the parking brake cable bracket bolts and remove the parking
brake cable.
|
Repair procedures
On-vehicle Inpection
•
Check that the battery cables are connected
to the correct terminals. ...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the fog lamp connector (A).
3.
Remove t ...
Seat Heater Switch. Schematic Diagrams
Schematic Diagram
...