Hyundai Accent Manuals

Hyundai Accent: Removal - ESC Control Module. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module. Repair procedures / Removal

1.
Turn ignition switch OFF.
2.
Pull up the lock of the HECU connector (A), and then disconnect the connector.
3.
Remove the brake fluid from the master cylinder reservoir with a syringe.
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
4.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
M11: 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
M14: 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.
Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

•
Never attempt to disassemble the HECU.
•
The HECU must be transported and stored in.
•
Never shock to the HECU.
6.
Remove the 3 bolts, and then remove the bracket from HECU.
Tightening torque:
11 ~ 14 N.m (1.1 ~ 1.4 kgf.m, 8.1 ~ 10.3 lb-ft)

ESC Control Module. Repair procedures
...

Installation
1. Installation is the reverse of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

CVVT Oil Control Valve (OCV). Description and Operation
Description Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated ...

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable from battery and wait for at least three minutes befo ...

Bodywork
High-gloss paint Do not use abrasive products or solvents, petrol or oil to clean the bodywork. Never use an abrasive sponge to clean stubborn stains. Risk of scratching the paintwork! Do not ap ...

Hyundai Accent Manuals


© 2011-2022 Copyright www.hamanual.com