Hyundai Accent Manuals

Hyundai Accent: Removal - Front Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Front Wheel Speed Sensor. Repair procedures / Removal

1.
Remove the front wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the front wheel speed sensor mounting bolt (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.
Remove the front wheel guard.
4.
Remove the front wheel speed sensor cable mounting bolt.
5.
Disconnect the front wheel speed sensor connector, and then remove the front wheel speed sensor.
6.
Installation is the reverse of removal.

Front Wheel Speed Sensor. Repair procedures
...

Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Repair procedures
Compession Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the comp ...

Inspection
Battery Diagnostic Flow Vehicle parasitic current inspection 1. Turn the all electric devices OFF, and then turn the ignition switch OFF. ...

Body Side Moldings. Repair procedures
Replacement Trunk Lid Garnish Replacement [Sedan] • When prying with a flat-tip ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com