Hyundai Accent Manuals

Hyundai Accent: Removal - Rear Wheel Speed Sensor. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor. Repair procedures / Removal

1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.8 lb-ft)

3.
Remove the rear seat back. (Refer to the Body group - Seat)
4.
Remove the rear wheel housing trim. (Refer to the Body group – interior trim)
5.
Disconnect the rear wheel speed sensor connector.
6.
Installation is the reverse of removal.

Rear Wheel Speed Sensor. Repair procedures
...

Inspection
1. Measure the output voltage between the terminal of the wheel speed sensor and the body ground. ...

See also:

Components and Components Location
Components Location 1. Overdrive clutch (OD/C) 2. One way clutch (OWC) 3. Low & Reverse brake (LR/B) 4. Underdrive brake (UD/B) 5. 26 brake (26/B) 6. 35R ...

Inspection
Rotor 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the s ...

Removal
Engine removal is not required for this procedure. • Use fender covers to avoid damaging painted ...

Hyundai Accent Manuals

© 2011-2026 Copyright www.hamanual.com