Hyundai Accent: Removal

Hyundai Accent RB (2010-2018) Service Manual / Body Electrical System / Multifunction switch / Repair procedures / Removal

Wiper and Washer Switch

1.	Disconnect the negative (-) battery terminal.

2.	Remove the steering column upper (A) and lower (B) shrouds after removing 3 screws.

3.	Disconnect the connector(A). Release the lock of wiper switch using tool without removing the steering wheel and the clock spring. Remove the wiper and washer switch.

Multifunction Switch Assembly

1.	Disconnect the negative (-) battery terminal.

2.	Remove the steering wheel. (Refer to the ST group - "Steering column & shaft")

3.	Remove the steering column upper and lower shrouds after removing 3 screws.

4.	Remove the clock spring. (Refer to the RT group - "Airbag module")

5.	Disconnect the lighting switch connector and wiper & washer switch connector. Remove the multifunction switch assembly (A) after loosening 2 mounting screws.

Flasher Unit

1.	Disconnect the negative (-) battery terminal.

2.	Remove the flasher unit (A) under the driver's lower crash pad after disconnecting the connector and loosening the bolt.

Inspection

Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mu ...

Installation

Multifunction Switch 1. Install the multifunction switch. 2. Install the clock spring. 3. Install the stee ...

Hyundai Accent: Removal

Inspection

Installation

See also:

Hyundai Accent Manuals