1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to the BD group - "Front door")
|
3. |
Disconnect the power window switch module connector (A) from the
wiring harness.
|
4. |
Remove the power window switch module (A) from the door trim after
loosening the mounting screws (5EA).
|
Seat Heater. Repair procedures
Inspection
Driver seat and Passenger seat
1.
Check for continuity and measure the resistance between terminals.
[Cushion]
...
Engine Mounting. Components and Components Location
Components
1. Transaxle mounting bracket
2. Rear roll stopper
3. Engine mounting bracket
4. Engine mounting support bracket
...
Troubleshooting
Troubleshooting
Problem
Possible cause
Solution
Not pairing
Bluetooth device of Car is not discoverable mode
Enter Bluetoot ...