1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the trunk lower trim.
(Refer to the BD group - " Trunk Lid")
|
3. |
Disconnect the rear combination lamp connector (A). Remove the
rear combination lamp assembly (B) after loosening 3 nuts.
|
4. |
Remove the bulb after turning in the counterclockwise direction.
A : Tail Lamp / Stop Lamp
B : Turn Signal Lamp
C : Back Up Lamp
D : Side marker
|
5. |
If necessary to remove the bulb, remove the bulb after pulling
the trim cover aside.
[Tail Lamp / Stop Lamp]
[Turn Signal Lamp]
[Back up Lamp]
[Side marker]
|
Injector. Description
and Operation
Description
Based on information from various sensors, the ECM can calculate
the fuel amount to be injected. The fuel injector is a solenoid-operated valve
and the fuel injection amount is c ...
Front Bumper. Components and Components
Location
Components
1. Front bumper cover
2. Radiator grill upper cover
3. Front bumper side bracket [ LH]
4. Front bumper side bracket [RH]
...
Installation
1.
Installation is reverse of removal.
Accelerator pedal
module installation nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6
...