Hyundai Accent: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the steering column upper and lower shrouds.
(Refer to the ST group - "Steering column")
|
| 3. |
Disconnect the ignition switch connector (B) and the key switch
connector (A) from under the steering column.
|
| 4. |
If it is necessary to remove the key lock cylinder (A), remove
the key lock cylinder after pushing lock pin with key ACC.
|
Inspection
1.
Disconnect the ignition switch connector (B) and key switch connector
(A) from under the steering column.
2.
Check for continui ...
Installation
1.
Install the key lock cylinder.
When assembling, the key must be inserted at ...
See also:
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Specifications
Specifications
Direct control VFS[OD/B]
▷ Control type : Normal high type
Control Pressure kpa
(kgf/cm², psi)
500.14 ~ 9.81
(5.5 ~ 0.1, 7.82 ~ 1.42) ...
Accelerator Position Sensor
(APS). Schematic Diagrams
Circuit Diagram
(M/T)
(A/T)
...
To decrease the cruising speed
Follow either of these procedures:
Push the SET- switch and hold it. Your vehicle will gradually slow down.
Release the switch at the speed you want to maintain.
Push the SET- switch and re ...
Hyundai Accent Manuals
В© 2011-2026 Copyright www.hamanual.com