When replacing the ECM, the vehicle equipped with
the immobilizer must be performed procedure as below.
[In the case of installing used ECM]
1) Perform "ECM Neutral mode" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer system")
2) After finishing "ECM Neutral mode", perform "Key
teaching" procedure with GDS. (Refer to Body Electrical System - "Immobilizer
system")
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS. (Refer
to Body Electrical System - "Immobilizer system")
|
1. |
Turn ignition switch OFF and disconnect the negative
(-) battery cable.
|
2. |
Disconnect the ECM Connector (A).
|
3. |
Remove the battery (Refer to "Charging System" in
EM group).
|
4. |
Remove the mounting bolts and nut, and then remove
the ECM bracket assembly (A).
|
Circuit Diagram
...
Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire
wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment.
When you have new tires instal ...
Rail Pressure Sensor (RPS). Troubleshooting
Signal Waveform
...