Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Remove the resonator and the air intake hose (Refer
to “Intake And Exhaust System” in EM group).
|
| 3. |
Disconnect the ETC module connector (A).
|
| 4. |
Disconnect the coolant hoses (A).
|
| 5. |
Remove the installation bolts, and then remove the
ETC module (A) from the engine.
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Installation
1.
Installation is reverse of removal.
Fuel pump plate
cover installation bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.44 ~
2 ...
Use high quality ethylene glycol coolant
Your vehicle is delivered with high quality ethylene glycol coolant in the cooling
system. It is the only type of coolant that should be used because it helps prevent
corrosion in the cooling syst ...
Components and Components Location
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com