1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
2. |
Disconnect the manifold absolute pressure sensor
connector (A).
|
3. |
Remove the installation bolt (B), and then remove
the sensor from the surge tank.
|
Inhibitor Switch. Schematic Diagrams
Circuit Diagram
...
Removal
1.
Release the residual pressure in fuel line (Refer
to “Release Residual Pressure in Fuel Line” in this group).
2.
Remove the rear sea ...
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the oil temperature sensor connector.
3.
Measure resistance between ...