Hyundai Accent: Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery
negative (-) cable.
|
| 2. |
Disconnect the crankshaft position sensor connector
(A) and remove the sensor (B) after removing the installation bolt.
|
Inspection
1.
Check signal waveform of CKPS and CMPS using a GDS.
Specification:
Refer to “Waveform”
...
Installation
•
Install the component with the specified
torques.
•
...
See also:
Removal
•
Do not spill brake fluid on the vehicle;
it may damage the paint if brake fluid does contac ...
Reassembly
1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
...
Airbag Module Disposal. Description
and Operation
Airbag Disposal
Special tool required
Deployment tool 0957A-34100A
Before scrapping any airbags or side airbags (including those in a whole
vehicle to be scrapped), the airbag ...
Hyundai Accent Manuals
© 2011-2024 Copyright www.hamanual.com